Geocortex Application Configuration

Most of the information gathered about Geocortex Applications is collected automatically from a variety of sources. For this reason, you cannot add an application and the settings you can configure are limited to establishing if the application is running. You can set the collection interval between probes as well as set alarms to fire if the response is not received or is too slow. You can set the collection interval of applications and alarms to affect all applications globally or a specific application.

Global Application Settings

On the Setup tab, you can select a Collection Interval to affect all Geocortex Applications.

On the Alarms tab, you can set alarms to fire when an all application fail to respond or are slow to respond.

Set Alarms on all Applications

To set alarms on all Applications:

  1. Open Analytics, and then click Configuration.

  2. In the sidebar, click Geocortex Applications.

  3. Select the Alarms tab.

  4. To enable an alarm if a response fails, click Alarm on Failed Response.

  5. To enable an alarm if a response takes too long, click Alarm on Response Time and then in the Response Time field, type in the number of seconds within which a response must occur. If the response exceeds this time, the alarm is triggered.

  6. In the Trigger After field, type in the number of times that the conditions must happen before the alarm triggers. The minimum number is 1, which means that the alarm triggers whenever the conditions are met. If you enter 2, the alarm triggers the second time a condition is met.

  7. Select Email or SMS if you want to receive an email or text when alarms are triggered.

Specific Application Settings

When a workflow runs on startup, that occurrence is not included in Analytics Reports under Geocortex Applications | Viewer Name | Trends tab | Tool Usage panel. If a workflow is run manually, it is included in the panel.

Set the Collection Interval to Probe Applications

On the Setup tab, you can set the collection interval to probe this particular application.

Set an Alarm for an Application

On the Alarms tab, you can set alarms to fire if probes to this particular application fail or take too much time:

Override Global Alarm Settings: Select if you want to set specific alarms for an application, and then enter the following:

© 2018 Latitude Geographics Group Ltd. All Rights Reserved.

Documentation Version 1.4